Designed to support U.S. DoD modernization strategies, REDCOM Sigma is a complete software-based Command & Control solution with voice, video, chat, and conferencing. REDCOM Sigma® increases the warfighter’s operational flexibility while reducing size, weight, and power (SWaP) requirements at the tactical edge. REDCOM Sigma is based on open standards with a focus on interoperability, flexibility, and ease of use, and is listed on the DoDIN Approved Products List (APL). REDCOM Sigma was selected by the U.S. Army’s Program Executive Office Command, Control Communications-Tactical for network modernization at the tactical edge. Sigma is being deployed to multiple programs within the U.S. Army at the battalion level and below.

We are an EASA-certified APU manufacturer. To date, we have installed more than 7,000 PBS APUs. This APU includes completely new combustion chamber, new control unit allowing allow non-operating altitude up to 8,000 m AMSL. Redesigned fuel system. Continuous operation for 6 hours. Exceptional reliability. Start up to 6,000 m

Original compact design and long-term production know-how. System reliability and overall competitiveness.

Lumir is the first Korean company to successfully develop and manufacture this onboard equipment, delivering superior performance and significant cost savings compared to competitors’ products. By integrating non-volatile NAND flash devices into the image data handling unit, storage capacity has been significantly increased, with data retention maintained even when the power is off.The image data handling unit of the satellite is a core device that receives high-speed, large-capacity data output from Earth observation sensors mounted on the satellite—such as SAR or optical cameras—then compresses and stores the data in real time, while also performing encryption and encoding for transmission to ground stations. Lumir has successfully developed and manufactured this satellite-mounted device domestically in Korea for the first time, breaking reliance on imported technologies. This achievement secures Lumir’s competitiveness by delivering superior performance and significant cost savings compared to foreign products.

- Minimizing the station's door opening and closing time to support drones' quick entry and exit. - Structural design to minimize noise and vibration when opening and closing the door - Design and implementation of an interface for interaction between an automatic door system and a drone. - Automatically opening and closing door system - Automatic detection of drones through cameras and sensors, and safe storage and charging functions

The SC-SSGMRTM, a Seedcore Co., Ltd representative product, is a backplane transmission module that performs the I/O function of the SSGM(Synchronous Signal Generation Module). When the SSGM(Synchronous Signal Generation Module) board is plugged into the motherboard(Backplane) in front of the Chassis, you can extend the I/O function of the board by plugging the SC-SSGMRTM board into the back of the Backplane. Three 37-pin Micro D-sub ports are used to send synchronization signals generated by SC-SSGM to the outside or to receive external synchronization signals, Three separate MMCX output ports are prepared to support test equipment such as oscilloscopes, and you can convert them to various signals and output them.

PELICAN-D LW is a 640x512 elements, 15μm pitch, Type-2 SuperLattice (T2SL) technology based 2D Long Wave Infrared (LWIR) digital IDCA. The new ROIC outputs digital signal, similarly to SCD’s previous digital detectors: Sebastian-320, Sebastian-480, Sebastian-640, Pelican-D, Hercules, and Blackbird. Pelican-D LW is available in the same configurations as the standard (MW) Pelican-D, with a large variety of cold shield apertures and cooler types. The proximity board provides the FPA timing and sensitive power supplies. Camera-Link interface highly simplifies the integration of the detector to the system.

This solution follows a three-step process of input, processing, and output, utilizing imagery, DEM, AT, and spatial data to refine 3D models. The editing-based texturing function allows users to correct shape errors, occlusions, and distortions, while the automated texturing ensures consistency and accuracy through advanced geometric matching. Final outputs are stored in standard formats for broad practical applications.