The Fuel Heater is engine-mounted with fluid connections to both the engine fuel supply system and the engine lube oil system. The heater provides fuel heating for fuel de-icing, using engine lube oil flow during aircraft cold start and cold operation periods. REPAIR PROGRAM • Triumph has the expertise only the OEM can offer • OEM repairs are more dependable, increase MTBF and cost less long-term • Repair price is all inclusive • TAT 45 days approx

Our firm offers end-to-end GaN production capabilities, including fabrication, packaging, test, and failure analysis to meet custom requirements. To enable customer designs, a process design kit (PDK) is available with a design manual, sample layouts, and a non-linear device model. Options available include fabrication of customer-designed wafers (“PDK foundry service”) or custom design by TransEON and fabrication according to customer specs (“NRE foundry service”). For either option, volume levels available include pilot/engineering runs, multi-project wafers (MPWs), or full production runs.

- Interior lighting used by removing it from the upper cockpit mount - Adjust the DIM/BRT brightness by operating the knob switch - NVIS WHITE per MIL-STD-3009

Mechanical Characteristics: Faster Hob Spindle and Zero Backlash Builtin Torque Motor for C Axis and Zero Backlash Both Wet Cutting / Dry Cutting Supported Application of the High-Speed Ring Loader

Confronting climate change, designing quieter and more efficient airplanes, developing innovative satellites to observe the Earth's system: our sector is using its skills to their utmost to take action for the environment. Our two main objectives are to advance our technologies so that we can better observe our planet and to create sustainable air travel.

Developed and manufactured by MPS Microsystems based on customer specifications, this lens actuator forms an essential component of a laser guidance system for unmanned flying objects. It enables 2 lens groups to be displaced individually over a total range of 48 mm and makes it possible to focus a laser over a distance of several kilometres. The main technical difficulty inherent to this actuator lies in meeting very stringent requirements for alignment between the two lens groups (< 10 µm) and in maintaining a very small tilt of the lenses over their entire stroke (lateral deviation < 2 µm). The key part making it possible to ensure such specifications is a frame machined by milling from an aluminium block, into which the 2 drive systems are fastened. These systems each consist of a Ø16 mm brushless motor and a Ø4 mm ball screw with an axial play of less than 5 µm. Backlash-free and frictionless sliding of the lens holders is ensured by standard L306 linear ball bearings manufactured by MPS Microsystems.

The maximum transmission distance varies based on the following frequency-related specifications. Camera Frequency Max Cable Length ================ =============== 20 ~ 60 MHz 10 m 60 ~ 80 MHz 7 m 80 ~ 85 MHz 5 m The PoCL Bypass function supports Power over Camera Link (PoCL) operation from the Frame Grabber to the selected camera. However, the power supply to unselected cameras is automatically disabled. To prevent power cutoff, separate power must be provided to the cameras. Configurations are available as follows, including image signal amplification. [Features of CLM-30C4]  Fully supports the Camera Link interface (Area/Line Scan).  Provides manual (switch) or remote (RS232) camera selection.  Allows selection from one of four cameras configured for Base (Layer 1) or Medium/Full (Layer 2) levels.  Supports Base/Medium/Full setups (CC1~4, RS232, LVAL, DVAL, FVAL)  PoCL bypass function: Automatically powers only the selected camera when PoCL-compatible cameras, frame grabbers, and cables are used.  Supports pixel frequency from 20 to 85 MHz.  Supports PoCL signal bypass (patented).  Enables lossless transmission.  Provides additional full-duplex RS232 communication at up to 256 Kbps.  Features a locking DC power jack (Molex).