JEFF WRAITH II is the tactical goggle for Military & Law Enforcement. The lightweight goggles give you wide protective coverage with a comfortable fit for use. It is compliant with ANSI Z87.1 standard requirement, European CE standard, and exceed U.S. Military eyewear ballistic resistance requirement MIL-PRF 32432A, MIL-DTL-43511D. The Anti-Scratch & Anti-Fog coated polycarbonate lenses give you up to 99.9 protections form UV rays and you can wear the goggle with your glasses on.

This unit(SOU) supplies sealing oil to prevent mixing of hydraulic oil and liquefied methanol gas inside of FBIV(Fuel Booster Injection Valve) when the main engine operates. SOU is divided into large bore main engine(60 bore over) and small bore main engine(50 bore below) type by the number of membrane accumulator. The main components consist of an oil tank, an electric motor, a hydraulic gear pump, an oil filter, a control block, accumulators, and various senses, transmitters and indicators.

The new Super-TAC IMU integrates three fiber optic gyros that exceed tactical grade performance with three high-accuracy Micro-Electro-Mechanical Systems (MEMS) accelerometers and state-of-the-art support electronics in a single small, lightweight package. This solution addresses the need for superior inertial performance in a tactical- grade package, critical for operation in GPS denied and contested environments. The Super-TAC IMU measures change in velocity and angle, utilizing a configurable variable synchronous data link control (SDLC) digital serial bus. The Super-TAC is configured to offer customers the best value solution when designing new systems as well as provide the flexibility to upgrade existing platforms. The Super-TAC IMU employs state-of-the-art optics with fewer components, providing significant performance and reliability improvements across standard military environments. Background Emcore, located in Budd Lake, NJ has been designing, developing and producing inertial components, sensors and navigation systems for Space, Ground, and Avionic applications for over 35 years. Emcore has been developing Fiber Optic Gyros (FOGs) since the early 1990s, producing and delivering IMU products with performance ranging from tactical to strategic grade PERFORMANCE GYRO PERFORMANCE Bias Stability < 0.05 °/hr. (1σ) Angle Random Walk ( ARW) ≤ 0.01 °/√hr. (1σ) Scale Factor Repeatability ≤ 100 ppm (1σ) Scale Factor Linearity ≤ 50 ppm (1σ) Angular Rate Range 1,000 °/sec Acceleration Range 100,000 °/sec2 ACCELEROMETER PERFORMANCE Range ± 25 g Bias Variation ≤ 50 μg (1σ) Scale Factor Stability ≤ 300 ppm (1σ) SYSTEM PERFORMANCE Bandwidth (adjustable) 800 Hz (gyros) 150 Hz (accelerometers) MTBF >25,000 hr.

Features - Excellent absorption performance (Max: -25 dB, Avg: -10 dB) - Withstands 00 minutes at 000 °C - Easily applicable to complex structures, including curved surfaces, gaps, and protrusions - Low dry density and specific gravity - Reduced number of coating layers (improving workability) - Passed environmental resistance and durability tests according to the operating conditions of guided missiles. - Insulating properties to minimize the effects of lightning

3U OpenVPX SSD is a rugged, reliable, high-performance NVMe SSD solution. Since the 3U OpenVPX SSD is a NAND flash-based SSD, reliability is improved in environments with vibration and contaminants compared to existing hard disk drives (HDDs). Additionally, it has the advantage of low latency and high-speed data transfer speed through the NVMe interface based on PCI Express. This is a significant advantage in high-risk combat environments.

ts advanced integrated optics and closed-loop Field Programmable Gate Array (FPGA) electronics deliver much higher accuracy, lower noise and greater efficiency than competing technologies. In addition, the EG-1300 can be calibrated internally for better thermal effect and has both digital and analog outputs, along with separation of the electronics from the FOG’s sensing coil assembly to accommodate the widest variety of installation parameters. Features Fully-integrated optics and electronics Advanced optics and FPGA electronics for higher accuracy, lower noise and greater efficiency Precise navigation (1 mile/hour without GPS) Fast, precise gyrocompassing to 1 milliradian Bandwidth to 500 Hz Separate electronics and sensor modules More economical than competing systems Applications Navigational grade applications Unmanned aerial vehicle (UAV) guidance Missile guidance Aeronautics and aviation Robotics

The RFcore Radar series are FMCW type radar and were developed to detect/track small air targets. The major difference between three models is detection performance. RX32B is fundamental model. RX128B have four times larger radar than RX32B. RX192A have six times larger radar then RX32B. The number of the product name means the number of antenna elements. All have compact and lightweight physical architecture that concentrates all the components required for radar, such as antenna, RF components and radar signal processor, in a small single housing. Transport can be carried in the carrier box and can be easily carried by one person. For installation, you can use a commercially available camera tripod. The weight is about 7.5kg (RX32B) and 15.9kg (RX128B), and the lower connection part is compatible with the tripod connection for the camera. Power supply requires 12VDC (RX32B) and 24VDC power (RX128B and RX192A). When using a battery, it is possible to connect a 12V battery or 24V battery to radars. Usage time may vary depending on the battery capacity. RFCORE recommended the constant power supply. Transfer of Status and BIT information and simple control of the RX32B, RX128B and RX192A are possible with a web browser using the Ethernet connection for authorized users. Using the terminal program provided with the radar, you can view the radar control and detected target information in real time. All RX Radar series’ Power Amp and Core Chip were designed using RFcore's own products.

Broad range of specialized Coaxial, Triaxial and custom options for Network/Communications, Data Transfer, High Frequency/Micorwave and Inflight Entertainment Cable Demands • EMI immunity • Low Loss • light weight • Superior resistance to high temperatures and harsh environments • More flexible/Tighter bend radius