DA 22-BLDC Brushless Actuator To guarantee maximum safety and reliability, its brushless motor and contactless, wear-free position sensing system makes the DA 22 BLDC immune to wear, vibrations and shock loads. It has especially been designed for usage in harsh environments and for safety-critical applications that require an actuator with high endurance. The conductive aluminum case and the shielded connection cable are reducing the susceptibility to any kind to EMI/RFI noise to the absolute minimum.

Our product range includes caps, chains, adapters, and locknuts, all manufactured through advanced CNC machining to ensure long-lasting performance even under frequent assembly and disassembly. These accessories are widely applied in electronics, aerospace & defense, and medical devices, where durability and reliability are critical. With the ability to provide customized designs and precision machining, we guarantee consistent quality, fast delivery, and compatibility with international standards, earning long-term trust from global clients.

Magnetic sensors (Hall effect) for air and land applications fly by wire

We manufacture clamps, latches, hinges, fasteners, exit door handles etc.

Innovative BMS sensing cable that allows the assembly (SMT) of components onto the pattern circuit without any length restrictions (0.1~3m) using the Roll-to-Roll process, and The manufacturing process of the conventional BMS sensing cable is shortened to 1/3.

The MIL-DTL-5015 series of connectors were developed as military standard connectors and applied to various military equipment, it is also used in general industries, medical care, electric vehicles, robots and automation facilities based on its high durability and reliability. This series is threaded coupling and the connection between the contact and the wire is based on soldering. It can be used compatibly with third-party products of the same standard since it is produced according to military standards.

Our LiDAR uses a custom-designed laser that separates 1064 nm and 532 nm wavelengths from a single source, with two dedicated receivers capturing each set of data independently. Inside the system, the linear laser beam is refracted at a 10-degree angle through a prism to enable circular scanning. An RF module is also integrated for real-time equipment status monitoring. From circuit board design to component selection, every part of this system was developed in-house by multiple institutions. As a result, we have successfully eliminated reliance on foreign technology.

Side shells, wing shells and fuselage structures are made of CFK, GFK, aluminium or organic sheets and get connected during production. Sealants are used to seal the connection surfaces. These are usually two-component polysulphides, which have to be applied in different geometries. Typical applications are: Fillet sealings, oversealings, interface sealings and seal caps. Due to their properties, polysulfides require very low pressure and shear handling. The compressibility of the fillers contained in the medium requires a high level of expertise and a coherent overall system from material removal to application. With manual application, long production times and high material ejection have a negative influence on the complete process. Complex quality standards are required due to the risk of human error. With the in-house developments of the vipro-DUOMIX from ViscoTec, this process can be depicted fully automatically. The individual nozzle design is also adapted to each application. The result is a controlled dosage in compliance with the specifications and at the same time the highest repeat accuracy.