Engineering Design Assistance Material Research & Development Manufacturing

Electric motor used to drive the joint (ST axis) of the Explosive Ordnance Disposal (EOD) Robot.

The R10s is a reconnaissance and surveillance drone capable of conducting up to two hours of mission flight, transmitting real-time information such as target location and scale to the ground control system. Based on the company’s innovative vertical take-off and landing (VTOL) platform “Bluebird,” the R10s is equipped with EO/IR optical sensors and a laser range finder for advanced target detection. Upon receiving mission orders, the R10s takes off vertically, transitions to fixed-wing flight, and proceeds to the designated area. Its onboard cameras and sensors identify and track targets, relaying precise coordinates to the ground control system. With modular wing replacement, the R10s can be configured for extended endurance of around two hours or for high-speed maneuverability, ensuring optimal adaptability and mission effectiveness across diverse operational scenarios.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

With advanced 3D printing, our turbine blades redefine manufacturing—delivering faster development, higher efficiency through superior quality, and innovative design freedom.

The HPC2812 is a rugged 6U VPX high-performance computer aligned with the compute-intensive SOSA profile, delivering top-tier processing with dual Intel® Xeon® D-2700 (Ice Lake-D) processors and flexible expansion capabilities. • Supports up to 128 GB DDR4 SDRAM with ECC and 480 GB NAND Flash (NVMe SSD) per node • Offers 2× 100 GbE (or 4× 40 GbE) data plane with RDMA, PCIe Gen 4 expansion plane, plus control and management plane support • Features the Xilinx® Zynq® UltraScale+™ MPSoC FPGA for enhanced security

A device that integrates and displays comprehensive navigation information for submarines, enabling operators to control various navigation sensors and systems while supporting mission execution. - Compliant with MIL-SPEC standards (shock, vibration, temperature/humidity, EMI/EMC) - Mechanically engineered design for improved maintainability

This unit(SOU) supplies sealing oil to prevent mixing of hydraulic oil and liquefied methanol gas inside of FBIV(Fuel Booster Injection Valve) when the main engine operates. SOU is divided into large bore main engine(60 bore over) and small bore main engine(50 bore below) type by the number of membrane accumulator. The main components consist of an oil tank, an electric motor, a hydraulic gear pump, an oil filter, a control block, accumulators, and various senses, transmitters and indicators.