It is commonly used in industrial and other devices to generate triggers ranging from one to several thousand FPS, ensuring precise timing synchronization with various devices. Periodic Mode: Continuously generates trigger signals after configuration. Burst Mode: Generates a single trigger signal upon receiving the best command via serial communication. *** Product Expansion and Usage ***  Four Operating Modes  Periodic mode: Generates a single-cycle signal based on the configured frequency and duty ratio.  Burst mode: Generates a single-cycle signal synchronized with a software trigger.  External trigger mode: Generates a single-cycle signal synchronized with an external trigger.  External trigger bypass mode: Distributes signals triggered externally.  Connect the trigger output signals from a Master Trigger Generator to a Slave Trigger Generator (as shown below).  By connecting one of the Master TG’s Trigger Outputs (1 to 16) to the Slave TG’s External Trigger Input: Outputs 1 to 15 of the Master TG remain unchanged. Outputs 16 to 31 of the Slave TG will mirror the Master TG’s Trigger Output. (Note: Each trigger signal passing through a TG experiences a delay of ten ns. However, since trigger outputs operate in the range of tens to thousands of Hz, users will not notice the delay).  Example with 17 TGen-16C units: Produces up to 256 Trigger Output Channels (16 × 16).

Border security and coastal surveillance are 24/7 operations that can’t afford downtime or periods of reduced readiness. Guarding against illegal immigration, smuggling, and terrorism demands reliable long-range threat detection and positive identification of potential threats all day, all night, and in all conditions.

Temperature Calibrated Pressure Sensors The Air Data Unit features very high accuracy absolute and differential pressure sensors. These are factory calibrated over a wide temperature range to further increase measurement accuracy and provide the best air data possible through varying conditions. Power Up Self-Calibration On top of factory temperature calibration, every time the air data unit powers up, it performs a self excitation calibration to adjust for small deviations of bias and scaling error. This allows the system to compensate for calibration aging and means that it never needs to be returned to the factory for recalibration. Reliability The Air Data Unit is built on top of a safety oriented real time operating system and all software is designed and tested to safety standards with fault tolerance. Its communication interface is optically isolated and the hardware is designed and tested to MIL spec.

- Lens cover device: protects the lens from stones and other foreign objects - Manual opening/closing device: allows manual operation in case the automatic mechanism fails due to foreign object blockage or freezing

PILAR vehicle version is designed for the protection of heavy and light armoured vehicles, as well as police armoured vehicles. It is available as a tetrahedral acoustic array mounted on the vehicle roof. It can also include a display indicating the shot origin and identification. This system has been fitted on several hundred vehicles of the French Army and users on various theatres of operations (Afghanistan, Central African Republic, etc.) have been very satisfied.

ElectroAir’s mobile APA-65 -series combined units consist of frequency converter units (AC rated output power up to 45 kVA) and rectifier units (DC continuous current up to 800A). These units are intended for the ground servicing of all aircraft types with a frequency of 400Hz and voltage 115/200 V and to power on-board electrical equipment and launch aircraft/ helicopters with a voltage of 28.5 VDC. APA-65 series is designed to eliminate CO2 emissions with its unique technical characteristics. Diesel hybrid unit and battery driven unit - unit can perform the complete service of aircraft at remote parking places with diesel engine / through batteries and it is also capable to operate from the 50/60Hz, 400V, 3 phase main power supply grid as any electrical GPU, without fuel consumption and with zero operating emissions. The range of different APA configurations with no emissions allow for safer, cleaner and more practical operational conditions for operators and personnel at the location. These units are very compact in size and weight.

Radio interference on telecommunications / broadcasting satellites operating in and outside of the country may result in degradation and interference of telecommunications / broadcasting. This system searches the interfering sources by TDOA / FDOA.

Mil-COTS Isolated DC-DC converters brings SynQor’s field proven high-efficiency synchronous rectifier technology to the Military/Aerospace industry. These “off-the-shelf” converters are compatible with the industry standard format, operate at a fixed frequency, and follow conservative component derating guidelines. MilQor products are designed and manufactured to comply with a wide range of military standards.