PILAR Ground Version can be deployed to enhance the surveillance and security of sensitive sites and events. It is the ideal product configuration to ensure optimum operational success in both defence and homeland security scenarios such as: - Military FOBs - Border Control Post - Embassies - VIP gatherings (G8, parades, commemorations, etc.) - Communities (airports, campus, sporting events, railway station, etc.)

A connector in military or aerospace applications is a device used to join electrical wires, cables, or circuits securely, ensuring reliable signal and power transmission under harsh conditions.

Missions is the only commercially available analysis tool which brings together aircraft definition, aircraft performance and cost investigations in a single environment and delivers reliable projections of key metrics such as payload capacity, maximum range and direct operating cost. Excellent runtime performance and the integrated analysis environment ensure fast results even when dealing with large route networks.

The SC-SBCRTM-V2 is a Rear Transition Module (RTM) designed to extend the I/O functionality of the SBC6511 single-board computer. Mounted on the rear side of the main VPX backplane, this module provides additional I/O expansion through Micro-D and D-sub connectors for synchronization signals, two Ethernet ports, two Mini-DisplayPort video outputs, two USB interfaces, and MMCX connectors. It enhances system flexibility and connectivity for embedded and radar signal-processing applications.

12kW DBC HEL Source for C-UAS

- Application of patented expansion technology to resolve narrow space operation. - Equipped with camera function utilizing foldable mast. - Drone take-off and landing system using internal lift. - Equipped with a monitor for situational identification and a console for drone operation control.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

Main Characteristics Excellent broadband characteristics Radiation patterns virtually independent of frequency Only one antenna required to cover a wide frequency range Selectable polarization plane Sturdy construction Suitable for mobile use Main Use Optimized for radiomonitoring and measurements Design Owing to its broadband characteristics and the virtually frequency-independent radiation patterns, the SLP – 200M-001G covers a very wide frequency range The sturdy construction makes the antenna Suitable for stationary and mobile applications