The SC-SBCRTM, a Seedcore Co., Ltd representative product, is a backplane transmission module that performs the I/O function of the SBC627. When the SBC627 board is plugged into the motherboard(Backplane) in front of the Chassis, you can extend the I/O function of the board by plugging the SC-SBCRTM board into the back of the Backplane.

ABC designs and develops many components or functions to best meet the requirements of the needs in the special functions required in the test facilities. Essentially, these are hydraulic components that cover all types of fluids from very low pressure to very high pressure in a very wide scope of flow ranges.

A distributed sensor system based on BOTDA (Brillouin Optical Time Domain Analyzer), capable of detecting structural deformation and external intrusion.

Designed to support U.S. DoD modernization strategies, REDCOM Sigma is a complete software-based Command & Control solution with voice, video, chat, and conferencing. REDCOM Sigma® increases the warfighter’s operational flexibility while reducing size, weight, and power (SWaP) requirements at the tactical edge. REDCOM Sigma is based on open standards with a focus on interoperability, flexibility, and ease of use, and is listed on the DoDIN Approved Products List (APL). REDCOM Sigma was selected by the U.S. Army’s Program Executive Office Command, Control Communications-Tactical for network modernization at the tactical edge. Sigma is being deployed to multiple programs within the U.S. Army at the battalion level and below.

Our LiDAR uses a custom-designed laser that separates 1064 nm and 532 nm wavelengths from a single source, with two dedicated receivers capturing each set of data independently. Inside the system, the linear laser beam is refracted at a 10-degree angle through a prism to enable circular scanning. An RF module is also integrated for real-time equipment status monitoring. From circuit board design to component selection, every part of this system was developed in-house by multiple institutions. As a result, we have successfully eliminated reliance on foreign technology.

EpiShuttle is all about protecting both patients and health care professionals. The EpiShuttle is an isolation unit designed for quick and easy transport of highly infectious and vulnerable patients.

Linden Photonics cables ensure stability and reliability even in extreme environments. With patented LCP jacket, non-kink design, maximum continuous length of 50 km, and crush-resistant durability, Linden Photonics provides high-performance cables optimized for deep-sea and aerospace applications.

ts advanced integrated optics and closed-loop Field Programmable Gate Array (FPGA) electronics deliver much higher accuracy, lower noise and greater efficiency than competing technologies. In addition, the EG-1300 can be calibrated internally for better thermal effect and has both digital and analog outputs, along with separation of the electronics from the FOG’s sensing coil assembly to accommodate the widest variety of installation parameters. Features Fully-integrated optics and electronics Advanced optics and FPGA electronics for higher accuracy, lower noise and greater efficiency Precise navigation (1 mile/hour without GPS) Fast, precise gyrocompassing to 1 milliradian Bandwidth to 500 Hz Separate electronics and sensor modules More economical than competing systems Applications Navigational grade applications Unmanned aerial vehicle (UAV) guidance Missile guidance Aeronautics and aviation Robotics