It is commonly used in industrial and other devices to generate triggers ranging from one to several thousand FPS, ensuring precise timing synchronization with various devices. Periodic Mode: Continuously generates trigger signals after configuration. Burst Mode: Generates a single trigger signal upon receiving the best command via serial communication. *** Product Expansion and Usage ***  Four Operating Modes  Periodic mode: Generates a single-cycle signal based on the configured frequency and duty ratio.  Burst mode: Generates a single-cycle signal synchronized with a software trigger.  External trigger mode: Generates a single-cycle signal synchronized with an external trigger.  External trigger bypass mode: Distributes signals triggered externally.  Connect the trigger output signals from a Master Trigger Generator to a Slave Trigger Generator (as shown below).  By connecting one of the Master TG’s Trigger Outputs (1 to 16) to the Slave TG’s External Trigger Input: Outputs 1 to 15 of the Master TG remain unchanged. Outputs 16 to 31 of the Slave TG will mirror the Master TG’s Trigger Output. (Note: Each trigger signal passing through a TG experiences a delay of ten ns. However, since trigger outputs operate in the range of tens to thousands of Hz, users will not notice the delay).  Example with 17 TGen-16C units: Produces up to 256 Trigger Output Channels (16 × 16).

Next-generation satellite multi-band terminal system development project

HYPER Series offers the original superior performing hyperboloid contact technology designed for use in all applications and in harsh and demanding environments where high reliability and safety are critical. The inherent electrical and mechanical characteristics of the Hypertac® HYPERboloid conTACt ensures unrivalled performance in terms of reliability, number of mating cycles, low contact force and minimal contact resistance. The shape of the contact sleeve is formed by hyperbolically arranged contact wires, which align themselves elastically as contact lines around the pin, providing a number of linear contact paths.

Receives vibration signals from an accelerometer installed on the aircraft engine and monitors engine vibration. Processes real-time vibration signals and converts them into IPS AVG units for output. Developed for localization, achieving 50% cost competitiveness compared to equivalent products. - x1 MIL-STD-1553B - x2 UART(RS-422/485) - x2 Accelerometer sensor - Sample rate : Up to 5,000Hz - Size : 220 x 206 x 52 (mm) - Weight : 1.75Kg - Environment : MIL-STD-810G - EMI/EMC : MIL-STD-461G - Power : MIL-STD-704F (28VDC, 10W)

- A white light mounted on the rear side of the aircraft to indicate the aircraft's location - These lights indicate the aircraft's position, flight direction, and attitude - Visible/IR Mode, Steady/Flash Mode - Light Intensity : FAA FAR 29.1391 ~ 29.1395 - SAE ARP 5825A

The SWIR & NIR 25-250mm f/5.5 (NFOV) f/4.0 (WFOV) continuous zoom lens is a first to market low-Size, Weight, and Power (SWaP), compact lens, for the newly introduced 5μm SXGA, as well as for 10μm SXGA, and 15μm VGA SWIR detectors. The SWIR & NIR zoom lens employs a unique mechanical and optical design, resulting in an all-around smaller and lighter unit with only 860gr in weight, and 224mm in length, making it approximately 60% lighter than similar existing SWIR lenses. The SWIR lens is also chromatically corrected to support a broader short-wave IR wavelength regime from 0.7-1.7μm and operates with minimal distortion. The SWIR & NIR 25-250mm f/5.5 (NFOV) f/4.0 (WFOV) continuous zoom lens presents an unrivaled combination of SWaP capabilities, detection range exceeding 26km. Product features: • Continuous zoom in the 0.7-1.7μm SWIR regime • Designed for 5μm, 10μm SXGA & 15μm VGA SWIR detectors • Lightweight (<860 gr) • Detection range >26 km • Enables laser-line detection

characteristicRear wheel drive type (5 forward speeds, 1 reverse speed) Cable Remote Control Type 2nd and 3rd speed Triple Synchro applied apply2.5-ton trucks and medium-sized buses, 3.5-ton trucks and medium-sized buses