STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

Highest Productivity with reliable part quality • Maximize productivity by using up to 4 lasers, advanced scanning strategies and bidirectional recoating. • Maintain reliable part quality by using uniform gas flow and precise 3-axis scanner motions. • All features are designed with minimizing the cost per part in mind to maximize your profitability. Automation of processes and minimize job to job time. • For increased operational efficiency, powder handling, powder sieving are optimized. • The job to job time is minimized by using exchangeable build containers. Best in class volume • Offering uninterrupted 24/7 series production utilizing the segment‘s largest build volume and sophisticated powder management. • This allows for printing of a wide range of mid to large size fully functional components. Easy to Print with a wide range of materials • DLX enables the production of highly precise and high-quality printed parts with a wide range of materials. • Standard materials are Aluminium, Titanium, Copper, Inconel, Maraging Steel, Stainless Steel and more.

From parts supply to total logistics support, GE has the right program to support your maintenance needs -- and keep more of your assets in their theater of operation. Our extensive maintenance management experience can maximize your engine and parts availability by improving procurement lead time and boosting shop productivity.

MPS linear actuators are very compact, offer outstanding precision and can be adapted to the most demanding environments. The ball screws that make up these actuators give them a smooth, stick-slip-free linear motion. The diameter, motor, screw type and other elements of the linear actuator can be configured to your requirements.

New generation hydraulic test stand built with hydraulic purification system keeping aircraft flight safer and reduce significantly aircraft maintenance cost.

12kW DBC HEL Source for C-UAS

The maximum transmission distance varies based on the following frequency-related specifications. Camera Frequency Max Cable Length ================ =============== 20 ~ 60 MHz 10 m 60 ~ 80 MHz 7 m 80 ~ 85 MHz 5 m The CLR-30 amplifies and transmits Camera Link signals in Base/Medium/Full configurations (up to 10 Taps supported) from a camera to a PC frame grabber. Key Features  Fully supports the Camera Link interface (Area/Line Scan).  Supports Base/Medium/Full setups (CC1~4, RS232, LVAL, DVAL, FVAL).  Supports pixel frequency from 20 to 85 MHz.  Supports 10 Taps cameras.  Enables lossless transmission.  Provides additional full-duplex RS232 communication at up to 256 Kbps.  Supports PoCL signal bypass (patented).  Features a locking DC power jack (Molex) and SDR connectors.  Compact size compared to previous models.