Model-Based Systems Engineering (MBSE) is a methodology that integrates design, analysis, and verification activities throughout the system lifecycle using architecture models. By modeling requirements, functions, structure, and behavior, MBSE supports consistent and informed decision-making. Ansys SAM (System Architecture Modeler) supports the latest system modeling language, SysML v2, and enables both graphical and textual modeling, real-time collaboration, and model management. Ansys ModelCenter integrates various engineering tools and builds automated workflows, enabling what-if simulations and trade studies. By connecting architecture models with simulation models, it supports consistent design analysis and requirements validation using a single source of truth (ASoT).

For : Nose-Landing Gear Assembly Jig A350 Project 4.8m (L) x 2.5m (W) x 3m (H )

Ray Service, headquartered in Staré Město, Czech Republic, is an international innovative manufacturer of cable harnesses, electromechanical assemblies, and electronic equipment. It is also a distributor and integrator of cable components and system products. More than 30 years of experience and intensive development have resulted in a strong, modern enterprise, a reliable and sought-after partner on an international level.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

The most modern and capable airborne surveillance solution available in the market today, GlobalEye is a true multi-domain Airborne Early Warning & Control (AEW&C) solution. With its mix of modern active and passive sensors, it provides long-range, early detection and identification of objects in air, at sea and over land from a single platform and also can provide real-time information to units in the Air Force, Army and Navy. This enables situational awareness of the surrounding areas and early detection of threats.