STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

It is suitable for various low voltage and is safe low-voltage motor through thorough quality verification. Applications are AGV, AMR and Medical devices.

Nara Space’s first standard nanosatellite for Earth observation constellations with 7 optical bands and 1.5 m GSD. Launched November 2023 to the 525 km of the orbit, it has 2 years Mission Lifetime.

The ENM2000 is a vehicle-mounted mmWave base station integrating CU/DU/RU, working in conjunction with the EPNR4000, 5G Core, and application server. It enables ultra-broadband data communication that Sub-6GHz base stations cannot provide.

Magnetic sensors (Hall effect) for air and land applications fly by wire

The SC-SSGMRTM, a Seedcore Co., Ltd representative product, is a backplane transmission module that performs the I/O function of the SSGM(Synchronous Signal Generation Module). When the SSGM(Synchronous Signal Generation Module) board is plugged into the motherboard(Backplane) in front of the Chassis, you can extend the I/O function of the board by plugging the SC-SSGMRTM board into the back of the Backplane. Three 37-pin Micro D-sub ports are used to send synchronization signals generated by SC-SSGM to the outside or to receive external synchronization signals, Three separate MMCX output ports are prepared to support test equipment such as oscilloscopes, and you can convert them to various signals and output them.

The EXOpod is the most advanced cubesat deployment system on the market. It is available in 6U/8U, 12U and 16U sizes which can be broken down into smaller slots to accommodate cubesats of any size. EXOpod Nova, the latest generation of the EXOpod line, is rapidly expanding what the cubesat design standard (CDS) is capable of – cubesats launching with Nova can now increase the volume of their lateral protrusions by 400% and their mass by 30%, enabling a wider and more powerful array of satellite designs and use cases.