Processor - NXP Quad Core PowerPC QorIQT2080 up to 1.8GHz - 6 DMIPS/MHz per core (up to 43,200 DMIPS@1.8GHz) - 128b AltiVecSIMD unit (up to 72 GFLOPs@1.8GHz) Memory - 4GB soldered 64-bit DDR3L SDRAM with ECC - 256MB 16-bit NOR flash - 64GB SATA NAND SSD - 512KB NvRAM Form Factor - 3U OpenVPX - Conduction-Cooled

Side shells, wing shells and fuselage structures are made of CFK, GFK, aluminium or organic sheets and get connected during production. Sealants are used to seal the connection surfaces. These are usually two-component polysulphides, which have to be applied in different geometries. Typical applications are: Fillet sealings, oversealings, interface sealings and seal caps. Due to their properties, polysulfides require very low pressure and shear handling. The compressibility of the fillers contained in the medium requires a high level of expertise and a coherent overall system from material removal to application. With manual application, long production times and high material ejection have a negative influence on the complete process. Complex quality standards are required due to the risk of human error. With the in-house developments of the vipro-DUOMIX from ViscoTec, this process can be depicted fully automatically. The individual nozzle design is also adapted to each application. The result is a controlled dosage in compliance with the specifications and at the same time the highest repeat accuracy.

Spring loaded High Frequency Micro-D Coax Connectors (MDHC) offer low VSWR up to 40 GHz (typ). These connectors have a constant 50 ohm airline impedance interface and are 30% smaller than our SCX coaxial connectors.

The fully redundant DA 30-HT-D has been developed for applications with the highest reliability demands. The redundant – two channel – design of the actuator allows continuous operation even if one of the two channels has failed. All major components such as the electric motors, control and communication electronics, and power supply are available twice (redundant). The position sensor features a three channel design (for 2 out of 3 voting). Additionally, there are several sensors integrated to provide diagnostic information such as current consumption, supply voltage levels and temperature readings. All major components of the actuator are continuously diagnosed by the microcontrollers of the actuator and its health status can be read via the redundant RS485.

The 20W X-band BUC is a satellite ground transport terminal that includes a receive rejection filter and performs IF-to-X-band upconversion using an internal reference frequency. It features dustproof, moisture-proof, and waterproof protection, along with self-diagnostic functions such as fan and temperature alarms. The unit provides a total gain of over 50 dB and supports a wide bandwidth of 500 MHz. Its frequency stability is maintained within 0.35 ppm.

It is a product lineup that is proven in global markets and has world-class competitiveness. And it is being exported to more than 20 countries around the world.

- Comprehensive High-Frequency Electromagnetic Simulation - Analysis of ships, submarines, aircraft, fighter jets, and satellites including antennas - EMC and EMP analysis including cables - Radome and multi-antenna interference analysis - Wireless coverage, network planning, and spectrum management

Since 1993, AMR has become the leading and most recognised journal on defence analysis, affairs and news in the Asia-Pacific region. It is unbiased, objective and authoritative. The editorial content includes capability analysis, special reports and relevant news coverage from the region. It has become the top resource for those working in the Asian military and defence organisations.