The ECL4000 is an LTE outdoor base station developed for the U.S. CBRS market, providing a service radius of several kilometers and enabling seamless private LTE network service.

• Airframe wires & cables • Coaxial cables • Fire-zone & H.T. area cables • Power transmissions • Databus, quad ethernet & optical fibers

- Long life and precise movement control through fine-tuning - Shaft diameter 5mm~ - Accuracy G3~G7 - Shaft length differs depending on material, size, accuracy of shaft - Efficiency 85% or higher

Temperature Calibrated Pressure Sensors The Air Data Unit features very high accuracy absolute and differential pressure sensors. These are factory calibrated over a wide temperature range to further increase measurement accuracy and provide the best air data possible through varying conditions. Power Up Self-Calibration On top of factory temperature calibration, every time the air data unit powers up, it performs a self excitation calibration to adjust for small deviations of bias and scaling error. This allows the system to compensate for calibration aging and means that it never needs to be returned to the factory for recalibration. Reliability The Air Data Unit is built on top of a safety oriented real time operating system and all software is designed and tested to safety standards with fault tolerance. Its communication interface is optically isolated and the hardware is designed and tested to MIL spec.

The KX1-3046 is an X-band high-power MMIC amplifier fabricated on the GaN-on-SiC process. It operates from 8.0 – 10.5 GHz and typically provides 30W saturated output power with power-added efficiency of 46%. The KX1-3046 can support military and commercial radar systems. It is matched to 50Ω with integrated DC blocking capacitors on both RF input and output ports. The KX1-3046 is 100% DC and RF tested on-wafer. It is available in chip form. **Key Features** - Frequency Range: 8.0-10.5GHz - Small Signal Gain: 28dB - High Pout: 30W - High PAE: 46% - DC bias: Vd=28V @Idq=0.6A - Pulsed Vg: PW=100µs, DC=10% - Chip size: 2.95x3.1x0.1mm  

ts advanced integrated optics and closed-loop Field Programmable Gate Array (FPGA) electronics deliver much higher accuracy, lower noise and greater efficiency than competing technologies. In addition, the EG-1300 can be calibrated internally for better thermal effect and has both digital and analog outputs, along with separation of the electronics from the FOG’s sensing coil assembly to accommodate the widest variety of installation parameters. Features Fully-integrated optics and electronics Advanced optics and FPGA electronics for higher accuracy, lower noise and greater efficiency Precise navigation (1 mile/hour without GPS) Fast, precise gyrocompassing to 1 milliradian Bandwidth to 500 Hz Separate electronics and sensor modules More economical than competing systems Applications Navigational grade applications Unmanned aerial vehicle (UAV) guidance Missile guidance Aeronautics and aviation Robotics

Liquid Measurement Systems (LMS) provides fuel gauging and interface controls for service, maintenance, and flight crew personnel, at the primary refuel point on the aircraft.

External Refuel Preselect Panels can display the quantity of fuel in each tank, calculate the total quantity of fuel onboard, allow service teams to pre-select desired fuel quantity, and display fault codes. LMS’ external refuel preselect panels are compact, lightweight, and rugged systems that can be adapted to a variety of platforms.

- RWR receiver inspection and antenna performance measurement - EW receiver inspection - Check the azimuth and signal power of the RWR receiver