The SDT F 16 Combat Training Pod is mounted on F-16 and similar air platforms in an external pod, and ensures efficiency in exercises and in the provision of air-to-air and air-to-ground tactics training to pilots. SDT F - 16 Combat Training Pod features advanced air-to-air and air-to-ground combat training capabilities, such as real-time autonomous position generation, weapon simulation and real-time hit/miss notification, thanks to its long-range and high-speed RF data link and integrated processors. The system has mission planning, live monitoring, debriefing and analysis/evaluation features. The SDT F 16 Combat Training Pod enables training in real flight conditions and in multi-threat/target environments. Its high-speed data link and modular design mean that the System is also a Live-Virtual-Constructive (LVC) training infrastructure.

It is a system that performs missions such as monitoring, surveillance and reconnaissance by ejecting and launching a foldable fixed-wing drone from the canister(tube) launcher. It is equipped with EO/IR Cameras (Electro-Optical / Infra-Red), which are mission equipment for reconnaissance, so that effective day and night image information can be collected. The gathered image information is transmitted to the ground control system (GCS) in real time while detecting and tracking the target by applying AI-based image processing technology. The foldable fixed-wing UAV has a simple structure and light weight, so it can be stored and transported in the canister launcher, and can be operated immediately so that it can be operated without time delay, and if necessary, the air vehicle can be retrieved and re-used by using a net-type recovery system.

The L Series comes with frames in various lengths to accommodate a variety of module combinations. The frames range from a basic frame with just 2 side rails and 2 end caps, to more complex versions with jackscrews, backshells, cable clamps, etc.

JEFF FIREFLY is a perfect sunglasses for protecting the eyes and preventing reflection during daily or guard work. The glasses block wind and dust to protect the eyes. The Anti-Scratch & Anti-Fog coated polycarbonate lenses give you UV protection below 400nm. The TR-90 frame offers reliable comfort during use, as it is resistant to temperature changes even in extreme conditions such as deserts or harsh climates. Also, JEFF FIREFLY is comfortable to wear for a long time due to its lightweight fitting.

HPW series is a medium density PCB connector with mixed signal and power contacts, up to 15A each. The HPW Series has been designed to resist to the high levels of shock and vibration in the harshest environments of the commercial aerospace and defense markets.

Every Partnership Pavilion is staffed by an experienced event team. Whether it’s coordinating with the show organizer; providing technical support; assisting with contractors, catering, or translators; or tracking a shipment, Team Kallman will help.

Temperature Calibrated Pressure Sensors The Air Data Unit features very high accuracy absolute and differential pressure sensors. These are factory calibrated over a wide temperature range to further increase measurement accuracy and provide the best air data possible through varying conditions. Power Up Self-Calibration On top of factory temperature calibration, every time the air data unit powers up, it performs a self excitation calibration to adjust for small deviations of bias and scaling error. This allows the system to compensate for calibration aging and means that it never needs to be returned to the factory for recalibration. Reliability The Air Data Unit is built on top of a safety oriented real time operating system and all software is designed and tested to safety standards with fault tolerance. Its communication interface is optically isolated and the hardware is designed and tested to MIL spec.

This rocket nozzle featuring conformal cooling channels and isogrid ribbing was manufactured using EOS Copper CuCP, a pure copper material optimized for additive manufacturing. The production required approximately 72 hours, taking advantage of the exceptional thermal and electrical conductivity of pure copper to meet demanding aerospace performance requirements. As one of the few companies in Korea capable of performing metal additive manufacturing with pure copper, we provide advanced technical expertise and support OEM production as well as collaborative technology development projects with various industrial partners. The showcased component was designed by nTopology and demonstrates the synergy of advanced design optimization with state-of-the-art copper additive manufacturing.