Due to its lightweight nature, TYTO 100 can transmit photos/low-resolution video from Manned and Unmanned Platforms beyond line of sight. TYTO 100 features an all-in-one Certus SFX module and antenna, with power supply. Wi-Fi and Ethernet Connectivity can be easily paired with existing customer devices, and Global Satellite Connectivity can be added. The TYTO 100 can also be used as Standalone mode with built-in Battery.

We have taken the standard housing configuration of the P1 & P3 mounting dimensions while incorporating true differential pair contacts within the P1 & P3 dimensional constraints. P1 connector housing contains 21 position true differential pair blind mate contacts allowing board designers to carry high density differential pair signals from the LRU via motherboard to daughter-card plug in modules with a single connector P1 type housing.

The AB-M1300 is a 1.3 ton-class eVTOL AAM. With a wingspan of 10 meters, the AB- M1300 is a crewed–uncrewed hybrid aircraft aiming for commercialization in 2028. Falling under the Light Sport Aircraft (LSA) certification category, it can carry up to two occupants, reach a maximum speed of 400 km/h, operate for two hour of flight time, has a maximum take-off weight (MTOW) of 1.3 tons, and a payload capacity of 250 kg. The AB-M1300 is designed for a variety of missions, including mid-mile logistics, personal leisure use, and pilot training.

Solution Overview The AI-Based Command Decision Support System, "KWM," identifies battlefield targets and recommends optimal weapon system combinations. It supports end-to-end "Sensor-to-Shooter" execution for rapid, accurate, and efficient engagement and command decision-making. Main Features Identifies targets on the battlefield using integrated sensors and data Recommends the most effective attack strategies for both reconnaissance and attack missions Provides command decision support through real-time analysis and visualization Suggests and allocates optimal target formations and strike assets Supports on-site command and control with a user-friendly interface Key Advantages Enables quick, accurate, and efficient engagement of enemy targets Automated recommendation of attack strategies and allocation of strike resources Real-time synchronization between reconnaissance and attack kill webs Direct connection from detection to strike (Sensor-to-Shooter capability) Increases operational efficiency and decision-making accuracy in complex battlefield environments Applied Cases Successfully piloted in the Army Tiger Boost Project in 2024 Used for command decision-making and efficient allocation of attack resources in live military scenarios

Tactical Information Communication Network (TICN), a core system for network-centric warfare (NCW) It is a communication-based system that guarantees real-time command and control of reconnaissance, surveillance, command decision, and true strike in network-centric warfare (NCW), including network management system (TIPS)/switching system (TIPS), tactical mobile communications system (TMCS), and small-capacity transmission system. It is divided into five subsystems: (LCTRS), High Capacity Transmission System (HCTRS), and Multi-band Multi-Channel Multi-function Radio (TMMR).

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

The 200W High Power Amplifier is an L-band amplifier that delivers 200W output with a 60% duty cycle. It provides a gain of over 53 dB, with output flatness of 2 dB depending on the input signal level. At maximum output, it offers ACLR performance of -20 dBc. With a built-in output-stage bandpass filter (BPF), it achieves excellent harmonic suppression of -70 dBc. Built-in monitoring functions include output signal and temperature monitoring.

CI Systems사의 는 구성 가능한 소형 휴대용 미사일 방사 시뮬레이션 플랫폼입니다. MSS는 항공기 이륙 라인에서 정기 검사로 또는 실험실에서 미사일 경보 시스템(MWS)의 준비 상태와 성능을 테스트할 수 있도록 합니다. MSS는 자외선(UV) 또는 적외선(IR) 대역의 소형 방사 소스를 내장하고 있으며, 단일 또는 이중 방사 소스를 지원합니다. 이 소스는 내장된 마이크로프로세서에 의해 모드 조절되어 어떤 미사일이 방출하는 방사라도 현실적인 시뮬레이션을 제공할 수 있습니다. 사용자 친화적인 소프트웨어를 통해 어떤 테스트 프로파일도 MSS에 구성하고 업로드할 수 있습니다. Translated with DeepL.com (free version)CI Systems’ Missile Signal Simulator (MSS) is a configurable compact, hand-held, missile radiation simulation platform. The MSS enables the operator to test the readiness and performance of Missile Warning Systems (MWS) in the flight line as a routine test and in the laboratory. The MSS contains a miniature radiation source in the UV or IR band, with single or dual radiation sources. They are modulated by a built-in microprocessor capable of delivering a realistic simulation of the radiation emitted by any missile. Any testing profile can be configured and uploaded onto the MSS using a user-friendly software.