Features & Benefits: Drop-in enhancement for the T55-714A with very minor aircraft changes for deployment facility. Responsive to U.S. Army maintainer feedback, converting on lessons from current CH-47 engine. Upgrade Kit easily installed during overhaul.

암페놀-대신전자정밀(주)는 Amphenol Corporation의 한국 법인으로, 산업용, 군수용, 이동 통신 및 철도 차량용 커넥터를 주력 제품으로 생산하고 국내 시장 뿐만 아니라 수출 및 해외 암페놀 법인의 제품을 한국 시장에도 공급하는 공식 자회사입니다.

By supplying the highest level of products and services based on careful quality control management, our products have been recognized by various customers.

The device consists of a power supply, dedicated Iridium and GNSS antenna, BLE, three configurable inputs/outputs, RS232, and CANbus in an environmentally sealed enclosure. Includes an Iridium Short Burst Data (SBD) modem that allows remote devices to send and receive satellite messages from anywhere in the world.

Digital mission engineering tools connect every stage of the engineering product lifecycle, from initial design to operation. They enable reality-based 3D simulation across multi-domain environments such as air, space, land, and sea by incorporating high-resolution terrain, satellite orbits, RF and radar systems, and sensor environments to accurately replicate real mission conditions. With accurate dynamics-based physical models at the core, these tools provide quantitative analysis of relative positioning between systems, changes in altitude and attitude, line-of-sight availability, and communication link status. Users can predict and evaluate mission elements such as sensor operations, communication links, platform maneuvers, and orbit optimization through scenario-based simulations.

Rugged 2mm backplane connector system is a compliant PICMG Compact PCI standard solution that provides engineers with an advanced interconnect system to address the requirements of mission-critical applications within commercial aerospace, space and defense market segments.

High impedance D-Sub connectors are designed to ground the outer shield of a twinax or quadrax contact directly to the shell of the connector. A multi-finger ground spring fixed around the shell provides a multi-point contact engagement that affords superior EMI shielding. The end result is an extremely low contact resistance when measured from the contact outer body to the connector flange, ensuring minimal RF noise and high durability of over 500 mating cycles.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.