The device consists of a power supply, dedicated Iridium and GNSS antenna, BLE, three configurable inputs/outputs, RS232, and CANbus in an environmentally sealed enclosure. Includes an Iridium Short Burst Data (SBD) modem that allows remote devices to send and receive satellite messages from anywhere in the world.

This Ka-band antenna and data transmission device incorporates electronic beam steering antenna technology and software-defined radio technology as part of the Ka-band downlink system for satellites. It serves as a key component of data downlink systems within the satellite payload, supporting high-speed data transmission. The device enables system optimization through miniaturization, lightweight design, and single-unit modularization.

For electrical and electronic signal connections inside and outside the hermetic equipment, it reliably protects the device from extreme temperature/humidity changes, vibration and physical/chemical effects, and transmits signals and currents without loss. These connectors use special glass or ceramic as insulation and are used in furnaces, power breakers, submarines, gas control systems, transformer safety devices, etc. Key features of closed connectors: It completely blocks the interior from the outside environment to keep it vacuumed or pressurized. Durability: It works reliably in extreme environments (high temperature, low temperature, humidity, chemicals, etc.). Electrical performance: It delivers electrical signals or power without loss.

EFFECTIVE RANGE : 600 m RIFLING : 1:7" Twist, 6 Groove R/H MAGAZINE CAPACITY : 30 rounds

Titanium Grade 1 Strip Titanium Grade 2 Bars-Sheets and Plates-Tubes and Pipes Titanium Grade 5 ELI Bars-Sheets and Plates Titanium Ti-6Al-7Nb Bars

The Pseudo-GNSS system is designed with tightly integrated firmware and hardware. The firmware generates PRN signals based on GNSS orbital data, modulates them to resemble real GNSS signals, and ensures time synchronization in a Master-Slave structure. A user-friendly GUI software enables easy device control. The hardware consists of a power unit, signal transmission unit, and communication unit. The power unit ensures stable supply through low-noise design, while the transmission unit radiates GNSS-like signals indoors. The communication unit supports Wi-Fi and wired connections for synchronization and control across multiple devices, with compatibility for smartphones and tablets to display positioning results.

With a peak torque of >200Nm / 1770 lbf-in and a rated torque of 80Nm / 708 lbf-in, the fully redundant DA 58-D is the strongest, electromechanical, fully integrated (actuator control electronics, position sensing, motor and drivetrain in one housing) actuator in the market. Besides the well-proven redundant RS 485 interface, the DA 58-D also features a redundant CAN bus interface. The DA 58-D has been developed for applications with the highest reliability demands. The redundant – two channel – design of the actuator allows continuous operation even if one of the two channels has failed. All major components such as the electric motors, control and communication electronics, and power supply are available twice (redundant). The actuator features a triple-redundant position sensor (2 out of 3 voting). Additionally there are several sensors integrated to provide diagnostic information such as current consumption, supply voltage levels and temperature readings. All major components of the actuator are continuously diagnosed by the microcontrollers of the actuator and its health status can be read via the redundant RS485 / CAN interface.

Our cargo system product line includes brackets, buckles, rollers and other hardware.