High Power Polarizing Beamsplitter Cube coatings are deposited on the hypotenuse of right angle prisms that are optically contacted. They are designed to separate an incident beam into its S and P polarization components with an average extinction ratio (TP/TS) in excess of 500 : 1. The incident energy is split into two orthogonally polarized beams that emerge at 90。with respect to each other. These coatings were developed specifically for use in high power pulsed and CW laser applications.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

Input : 24VDC Output : 270VDC N+1 System

Our LiDAR uses a custom-designed laser that separates 1064 nm and 532 nm wavelengths from a single source, with two dedicated receivers capturing each set of data independently. Inside the system, the linear laser beam is refracted at a 10-degree angle through a prism to enable circular scanning. An RF module is also integrated for real-time equipment status monitoring. From circuit board design to component selection, every part of this system was developed in-house by multiple institutions. As a result, we have successfully eliminated reliance on foreign technology.

Vehicle-type RF Jammer Systems provide protection to VIPs and convoys against remote-controlled explosives. These systems create a protective shield through RF broadcasting and neutralize threats activated by radio, mobile phones and wireless remote-controlled devices. Vehicle-type RF Jammer Systems can be easily integrated aboard all kinds of vehicles, and allows for reprogramming against changing situations. Continuous broadband operation Control from hand terminal Module selection Malfunction warning VSWR warning

Large mirrors are crucial in various optical systems, particularly long-range multi-spectral setups for defense, surveillance, and commercial use, like UAV optics and agricultural temperature monitoring. Aerospace applications, such as satellites and telescopes, are common. These mirrors come in different shapes and materials, including Al, Si, Ge, and Cu, spanning visible, UV, and IR spectrums. By using advanced CNC grinding, polishing, and diamond turning we provide precise surface forms, with tight tolerances, and multispectral performance. Our mirrors, up to 700mm in diameter, provide impressive specifications: 0.05% radius tolerance, less than 0.5Fr P-V irregularities, 0.1Fr RMS at 0.633μ, and sub-40Å RMS roughness. MKS Ophir's proprietary coatings enhance spectral performance and surface durability. Contact us to set a meeting at ADEX Seoul

Building on an unsurpassed legacy of success, GE continues to execute on bold technical initiatives to ensure even more demonstrable support to the warfighter and those in need of humanitarian relief.

Since 1969 providing mission critical antennas and support equipment to the defense, aerospace, and commercial industries worldwide.