공중 통신용 VHF/UHF 트랜시버 제품군 R&S®M3AR 제품군의 소프트웨어 정의, 다중 대역 지원 공중 트랜시버는 모듈식 설계와 첨단 기술로 높은 MTBF 값과 긴 수명을 제공합니다. 작고 가벼운 이 트랜시버는 뛰어난 성능으로 무인 항공기를 포함한 모든 유형의 항공기에서 작동할 수 있습니다. 언제든지 다른 파형을 설치해 사용할 수 있어 다양한 작전 시나리오에서 상호 호환이 가능합니다.

For aircraft operating in sophisticated, diverse, and dense threat environments, self-protection is crucial. With Saab’s fully Integrated Defence Aids Suite (IDAS) – a proven end-to-end, multi-spectral EW self-protection suite for rotary and fixed-wing platforms – you can take advantage of immediate and automatic countermeasure dispensing as well as instant warning and threat awareness to the crew. This is essential since survival depends on doctrine-tactics in combination with countermeasures. In short, with IDAS watching your back, you are well prepared for the most challenging missions, in the most demanding threat environments.

KJF makes comprehensive efforts to satisfy our customers with cost effective, high quality and on-time delivery support. KJF fabricated radar platform and shelters of KMSAM

- A white light mounted on the rear side of the aircraft to indicate the aircraft's location - These lights indicate the aircraft's position, flight direction, and attitude - Visible/IR Mode, Steady/Flash Mode - Light Intensity : FAA FAR 29.1391 ~ 29.1395 - SAE ARP 5825A

Magnetic sensors (Hall effect) for air and land applications fly by wire

It is commonly used in industrial and other devices to generate triggers ranging from one to several thousand FPS, ensuring precise timing synchronization with various devices. Periodic Mode: Continuously generates trigger signals after configuration. Burst Mode: Generates a single trigger signal upon receiving the best command via serial communication. *** Product Expansion and Usage ***  Four Operating Modes  Periodic mode: Generates a single-cycle signal based on the configured frequency and duty ratio.  Burst mode: Generates a single-cycle signal synchronized with a software trigger.  External trigger mode: Generates a single-cycle signal synchronized with an external trigger.  External trigger bypass mode: Distributes signals triggered externally.  Connect the trigger output signals from a Master Trigger Generator to a Slave Trigger Generator (as shown below).  By connecting one of the Master TG’s Trigger Outputs (1 to 16) to the Slave TG’s External Trigger Input: Outputs 1 to 15 of the Master TG remain unchanged. Outputs 16 to 31 of the Slave TG will mirror the Master TG’s Trigger Output. (Note: Each trigger signal passing through a TG experiences a delay of ten ns. However, since trigger outputs operate in the range of tens to thousands of Hz, users will not notice the delay).  Example with 17 TGen-16C units: Produces up to 256 Trigger Output Channels (16 × 16).