Temperature Calibrated Pressure Sensors The Air Data Unit features very high accuracy absolute and differential pressure sensors. These are factory calibrated over a wide temperature range to further increase measurement accuracy and provide the best air data possible through varying conditions. Power Up Self-Calibration On top of factory temperature calibration, every time the air data unit powers up, it performs a self excitation calibration to adjust for small deviations of bias and scaling error. This allows the system to compensate for calibration aging and means that it never needs to be returned to the factory for recalibration. Reliability The Air Data Unit is built on top of a safety oriented real time operating system and all software is designed and tested to safety standards with fault tolerance. Its communication interface is optically isolated and the hardware is designed and tested to MIL spec.

i3system’s line scanning X-ray detector platform, XID-C15DP/XID-C24DC, is a high performance and cost effective solution for dental panoramic, cephalometric applications. i3system’s direct type sensor ensures the most sharp images among the current products in the market. XID series is designed for compact size and easy installation. High DQE(Direct Quant㎛ Efficiency) enables high performance at lower dose of X-ray. Introduction Indirect type X-ray detector uses the scintillator and the photo-diode(CCD or CMOS sensor) for conversion of the X-ray into the light and for taking images espectively. But the light scatters and goes extinct during it passes through the scintillator and reaches to the CCD or CMOS sensor. As a result, it is inevitable to get blurred image. In the mean time, XID C15DP, direct type detector, converts X-rays into electronic signals directly without conversion process of light. Because X-ray is not converted into light, it provides much sharper images than indirect type detector. XID C15DP is designed to compact for easy installation. It provides Gigabit Ethernet port on the detector for easy configuration. Instead of Gigabit Ethernet, camera link or optical interface can be provided according to requirements of users.

LW-DED 3D printing head module for Morphing Shield Technology. Morphing Shield Technology builds aportable inert gas enviroment surrounding the melting zone for laser wire DED Process.

This miniature fin actuator manufactured by MPS Microsystems was designed based on customer specifications. Designed to guide a very small object and disposing of an extremely limited space, it meets strict requirements in terms of performance, weight - less than 100 g - and dimensions. To reduce the length of this actuator, MPS Microsystems used part of the screw length as the motor axis. This screw is equipped with a very compact 4-point contact bearing that simultaneously absorbs axial and radial loads. The angular play on the aileron axis is less than 0.1° rms. This actuator meets the storage and vibration requirements of military equipment.

Low Insertion Loss, Good IMD Performance RF Coaxial Switches: SPST to SP8T Switches, Transfer Switches from DC to 200 GHz Power Dividers and Power Combiners Wilkinson Types from 2 to 16 Ways Frequency Range from 400 MHz to 26.5 GHz

HDB0800SG is a HUD (Head Up Display) Repeater installed in fixed wing of Korean Air Force, which shows video information given from the cockpit HUD to the rear seat.

High durability and quick response even in harsh environment conditions. Applications are OHT system in semiconductor equipment and industrial robots.

Additive manufacturing: - allows highly efficient, compact recuperators with custom flow paths, maximizing energy recovery and reducing overall system emissions. - charge air coolers enhance cooling performance with tailored airflow designs, reducing intake temperatures and boosting engine efficiency. - delivers precise, space-efficient pre-coolers and heaters, ensuring optimized thermal response and energy efficiency for various industrial applications.