STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

Maximum Control for your interactive graphical displays. Developing HMIs for safety- and mission-critical avionics and embedded displays only gets more demanding. VAPS XT offers HMI designers, systems engineers, and embedded engineers maximum control and flexibility for creating interactive real-time graphical displays for avionics and other safety-critical embedded applications. With an open architecture and integrated logic capabilities, VAPS XT provides the essential features for the design and deployment of certifiable cockpit displays. VAPS XT provides a model-based environment supporting all phases of development from initial concept to embedded deployment. Through a flexible porting structure, VAPS XT applications can be easily deployed to virtually any embedded target with excellent performance.

Counter-UAS Solutions for Government & Defense

Receives vibration signals from an accelerometer installed on the aircraft engine and monitors engine vibration. Processes real-time vibration signals and converts them into IPS AVG units for output. Developed for localization, achieving 50% cost competitiveness compared to equivalent products. - x1 MIL-STD-1553B - x2 UART(RS-422/485) - x2 Accelerometer sensor - Sample rate : Up to 5,000Hz - Size : 220 x 206 x 52 (mm) - Weight : 1.75Kg - Environment : MIL-STD-810G - EMI/EMC : MIL-STD-461G - Power : MIL-STD-704F (28VDC, 10W)

A VGA (640×480) LWIR (8–12 µm) uncooled micro-bolometer module with 12 µm pixel pitch and NETD ≤ 50 mK, paired with an F1.0, 10.7 mm EFL lens delivering H42° / V31.5° / D52.5° FOV. It streams at 30 Hz in either UVC (USB-C, 5 V) or GMSL1 (FAKRA, 12 V), with power consumption < 1.9 W. The compact, lightweight housing (30×30×58.9 mm for UVC; 30×30×70.9 mm with FAKRA for GMSL1; IP65; −40 °C to 85 °C) makes it well-suited for autonomous vehicles, UAVs, and security systems, providing reliable day/night thermal perception of pedestrians, animals, and objects in adverse weather.

- To check and verify the RWR system on the aircraft and radiate threat signals to RWR antenna through couplers. - Radiate threat signals to jammer system.

TESCAN SOLARIS is a fully automated sample prep platform optimized for advanced devices with sub-10 nm features. It integrates the Triglav™ SEM, AutoTEM Pro™ software, and OptiLift™ nanomanipulator to enable hands-free, repeatable lamella prep in planar, inverted, or top-down geometries.