Leading edge high-speed opto-electronic modules, global communication needs made simple.

SAF-FIRES™ is a standards-based, image generator agnostic, and scalable Call-For-Fire and Close Air Support training simulation with autonomous Smart Trainer suitable for deployment in Joint Fires and accreditable JTAC training simulators. Built upon the same Call-For-Fire and Close Air Support software engine that powers the accredited simulation Fires FST™, SAF-FIRESTM delivers the same mature and complete Joint Fires training solution but makes it available for integration with any DIS, HLA or CIGI compatible simulation or Image Generator. Supporting both conventional near-peer and counter-insurgency operational scenarios, SAF-FIRES™ enables JFOs and JTACs to train realistically in a modern complex battlespace against an agile and adaptive adversary. Heightened realism and cognitively challenging training are enabled through the incorporation of non-combatants, urban clutter, UAV surveillance, various close air support platforms and accurate military targeting procedures.

Specialty Tool Kits and Custom Sheet Metal Kits

< Frequency Range > ● 20 ~ 1000 MHz < Output Power (W) > ● 100 < Gain (db) > ● 50 < Power Supply (V) > ● 32 < Current (A) > ● 10 < Dimension > ● 177.1 x 95 x 30 (mm)

Nas-52 or Night Attachable Sight gives law enforcement and military personnel the versatility in operations through attaching simple night vision device prefixed to daytime sight which makes available to engage in surveillance or to acquire targets regardless of ambient light conditions. NAS-52 is a clip-on system designed to mount in front of any kinds of daytime riflescope, and it gives daytime riflescope the night vision capability. Sniper or designated shooter using daytime scope will significantly need this performance for night time operation.

This product is designed and manufactured to meet customer needs, including power and signal transmission for all weapon systems in the Korean military's land, sea, and air sectors.

STIM300 is a small, tactical grade, low weight, high performance non-GPS aided Inertial Measurement Unit. It contains 3 highly accurate MEMS gyros, 3 high stability accelerometers and 3 inclinometers. The IMU is factory calibrated and compensated over its entire operating temperature range. STIM300 is a cost-effective ITAR free solution for systems that only had FOGs as an alternative when reaching for the performance level of that STIM300 can offer. Each axis is factory calibrated for bias, sensitivity and compensated for temperature effects to provide high-accuracy measurements. The unit runs off a single +5V supply and communicates via a RS422 interface. The use of a 32-bit RISC ARM microcontroller provides flexibility in the configuration, like choice of output unit, sampling frequency, LP filter -3dB frequency and RS422 bit-rate and protocol parameters. For more advanced users, STIM277H may be put in Service Mode. In this mode all the configuration parameters can be temporarily or permanently changed by overwriting the current settings in the flash memory. Service Mode also provides the ability to perform single measurements, perform diagnostics and obtain a higher detail in the status byte.

I'd like to introduce is the “Lightweight 105 Self-propelled Howitzer,” which is unveiled in 2024. This model is mounted on the small tactical vehicle, showcasing the strong collaboration within Hyundai Motor Group. This product is applying 105mm artillery and can also be utilized on the battlefield with a command vehicle, firing vehicle, and ammunition carrier. This system is optimized for "Shoot & Scoot" tactics, as each vehicle weighs less than 7 tons and can be airlifted by tandem rotor helicopters like the CH-47 Chinook. The number of the crew has been reduced from six to four, which enhances its mobility and efficiency. It boasts a maximum firing rate of 10 rounds per minute and a range of 14.7 kilometers. This Lightweight 105mm Self-propelled Howitzer was completed firing test and currently in the final stages of developing with the government agency. I am looking forward to manufacturing mass production in 2026.